|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
"Bubbatronics™" Electronic Flathead Distributor |
|
| We have shipped approximately 200 of the Chevrolet/Flathead conversions to very happy customers. A few of these have been electronic units using a variety of electronic conversions. Now we are doing a new electronic system using what we call "Bubbatronics™", We use our same Flathead Chevrolet machined housing and add the Chrysler reluctor and pick-up coil and a GM HEI module mounted to the distributor housing. Makes a nice package. | |
The following pictorial illustrates what our typical conversion consists of. |
|
| We gather up all the parts needed for the conversion. Mount the module with a couple 8/32 screws | |
|
|
 |
| Index and mount the pickup and reluctor. | |
|
|
|
| We cut the extension shaft a little smaller length so the distributor will fit a Merc cover as well as the Ford cover | |
 |
 |
| Tested unit to verify rotor index and phasing under load. This makes sure the rotor is being properly triggered and spark is at the correct timing. Pack it up and ship it to your door. | |
 |
 |
Call or E-mail us for Pricing! |
|
If it makes spark, we do it !!! |
|
| Bubba's Hot Rod Shop 1330 Main Street Speedway, Indiana 46224 1-888-809-3835 |
|
